Denali Cansmart gen 2 for the KTM 890 and 1290

Leverage the flexibility and intelligence of your KTM 890 or 1290's CAN-bus electrical system to significantly simplify accessory installation with the new and improved DENALI CANsmart™ Controller GEN II.

The DENALI CANsmart™ Controller offers plug-and-play installation and integrated control of up to four accessories, allowing dozens of customizable settings that can be controlled directly from your KTM switch cluster or the CANsmart™ Accessory Manager Software.

The CANsmart's four circuits are pre-programmed to independently connect and control two sets of DENALI lights, a SoundBomb horn and our B6-auxiliary brake lights.

Features:

• High/Low Sync: Converts auxiliary lighting between a programmable high/low setting with the original high beam switch.
• ON/OFF and Dim: Independent control of two sets of lights ON/OFF and intensity level change (both day and night) directly from the original vehicle switches.
• Modulate Light: Set auxiliary lights to modulate to increase your visibility to other road users.
• Flash to Pass: Need to get someone's attention? Pulse your high beam switch three times and your auxiliary lights flash three times rapidly.
• Cancel With Turn Signal: This feature cancels the corresponding auxiliary lights when you turn on your turn signal to prevent powerful auxiliary lights from overpowering your turn signal.
• Inverse Flashing With Hazards: This feature makes your auxiliary lights flash inversely to your hazard lights, increasing visibility during roadside emergencies.
• Plug & Play Horn System: Quickly and easily connect powerful aftermarket horns like our SoundBomb™ without adding an additional harness or relay.
• Strobe with Claxon: With this feature selected, the CANsmart™ software will automatically flash your auxiliary lights when you use your horn, regardless of whether you have the factory horn or SoundBomb™ horn installed.
• Deceleration Activated "Smart Brake" Technology: CANsmart™ reads vehicle speed in real time to activate your auxiliary brake light during deceleration, even before you touch the brake. Adjust the sensitivity and set the minimum speed at which the Smart Brake feature is activated.
• 1Flash Pattern Braking: The CANsmart™ offers four different flash patterns that make our very bright auxiliary brake lights even more noticeable to motorists behind you. You can set auxiliary brake lights to flash only when braking hard, flash continuously when braking, or flash four times rapidly and then hold (California legal flashing frequency).
• Circuit Function Selector: The Circuit Function Selector in the CANsmart software lets you run any accessory on one of four circuits.
• Switchable Power Source: The CANsmart™ provides a universal "accessory" option that gives you easily switchable 12V power. That means whatever accessory you connect to this circuit will turn on and off with your ignition.
• Time Out Delay: You can also set accessories on this circuit to have a delayed timeout. This will keep them off power for up to 30 seconds after turning off your engine.
• On Board Power: The "accessory" circuit option is ideal for powering your GPS, phone, heated clothing or any other electronic device.

What's in the box.

1. CANsmart™ Controller
2. (x2) 5.5ft Light Extension Cables
3. 5ft SoundBomb horn extension cable
4. Horn Triger Wire
5. B6 Brake Light Wiring Adapter
6. Tie-wraps
7. Self-adhesive Velcro attachment
8. Micro USB programming cable

Manual:

Mounting Denali Cansmart gen 2 for the KTM 890 and 1290